Casper Via E1 flash file (stock firmware) will assist you flash and restore your phone to its default factory state. It will eliminate root, infection, un-brick, and repair your gadget if it’s stuck on boot logo design. If your phone lags, after flashing it must be much better.
It is encouraged that you backup present firmware and all other crucial information since, flashing this firmware will totally remove your phone information. Just flash your gadget if you in fact understand what you’re doing. This is to prevent ruining your gadget, or turning it into a brick.
Subsequently, make sure the gadget is charged up to a minimum of 30% so the procedure is not cut off due to low battery. If there’s a damaged link, do not be reluctant to report through the remarks area or utilize the contact type.
| Version | Casper_Via_E1 _02062016 |
| Size | 819 MB |
| Firmware | Download |
Flashing guidelines
You require SP MDT, SP Flashtool, CM2, or Miracle Box, and so on to flash this firmware. Get a working USB cable television, then continue with flashing.
- Unpack downloaded firmware to an empty folder
- Make sure you’ve set up the needed drivers on your PC.
- Launch flashtool and load the firmware. You may require to wait a couple of seconds for it to procedure totally
- Now power off your gadget and click on this link to check out complete flashing guidelines
If you require any aid on this gadget or flashing guidelines, or you’ve got other contribution- do not be reluctant to publish in the remarks area listed below. We do our finest to respond and address your concerns.
