Flashing this Wiko y50 / Sunny 4 w-k130 flash file (stock firmware) will restore your phone to its default factory state. It will remove root, virus, un-brick, and fix your device if it’s stuck on boot logo. If the phone lags, after flashing it should be better.
You should consider making a backup of your current firmware, and all other important data on the phone, because flashing this ROM will erase your phone. Also, you should only flash your device if you actually know what you’re doing. To avoid messing up your device, or turning it into a brick.
It’s also important that your device is charged up to at least 30% so the process is not interrupted due to shutdown.
If there’s a broken link, do not hesitate to report via the comments section or use the contact form.
|W-K130-TMV-V01.15-20-8.1-ASI||Download | Download||816 MB|
You need tools like SPD Upgrade Tool (v24.0.0003), and other flashtools that support PAC files, to flash this firmware. Get a working USB cable, then follow the instructions below-
- Unpack downloaded firmware to an empty folder
- Make sure you’ve installed the required drivers on your PC.
- Launch flashtool and load the firmware. You might need to wait a few seconds for it to process completely
- Now power off your device and click here to read full flashing instructions if using SPD Upgrade Tool.
If you need any help on this device or flashing instructions, or you’ve got other contribution- do not hesitate to post in the comments section below. We do our best to reply and answer your questions.