Umidigi Crystal (2GB/4GB) factory stock firmware

Umidigi Crystal (2GB/4GB) official supply firmware will certainly assist you blink and also restore your phone to its default manufacturing facility state. It will certainly eliminate origin, virus, un-brick, as well as fix your device if it’s stuck on boot logo design. If your phone delays, after flashing it should be better.

Additionally, you must consider making a back-up of your current firmware, as well as all various other crucial information on your phone. Flashing will totally remove your phone. Likewise, you need to only flash your tool if you actually recognize what you’re doing. To stay clear of ruining your tool, or turning it right into a brick.

It’s likewise important that your device is billed up to a minimum of 30% so the procedure is not disturbed as a result of closure.

If there’s a damaged web link, do not hesitate to report via the comments section or use the contact type.

Firmware download link

Variant Build Firmware Size
2GB/ 16 GB V1.0 _20171201 system software Download 996 MEGABYTES
4GB/ 64 GB V1.1 _20171125 system software Download 1.07 GB

Flashing instructions

You need a tool like SP Flashtool, Miracle Box, AfterSales SWD Tool, and so on, to blink this firmware. Get a functioning USB cord, then comply with the directions listed below-

  • Unpack downloaded and install firmware to an empty folder
  • Make sure you’ve installed the needed drivers on your PC.
  • Launch flashtool and also load the firmware. You might require to wait a few secs for it to procedure totally
  • Now power off your gadget and also go here to review complete blinking directions if making use of SP Flashtool.

If you require any type of aid on this gadget or blinking guidelines, or you’ve obtained various other contribution- do not hesitate to post in the remarks section below. We do our best to respond and answer your concerns.