Ulefone S10 Pro factory stock firmware

Ulefone S10 Pro official stock firmware will certainly aid you blink as well as recover your phone to its default manufacturing facility state. It will certainly remove root, infection, un-brick, and also repair your gadget if it’s stuck on boot screen. If your phone delays, after flashing it should be better.

Additionally, you should think about making a back-up of your existing firmware, and also all various other essential data on your phone. Flashing will totally erase your phone. Likewise, you must just flash your device if you actually know what you’re doing. To avoid ruining your tool, or transforming it right into a brick.

It’s also essential that your gadget is charged up to a minimum of 30% so the process is not interrupted due to closure.

If there’s a busted link, do not wait to report via the remarks section or use the get in touch with form.

Firmware download web link

Build Firmware Size
GQ3070 QH1_KSS21 _ ulefone _20190322 _ G15 Download 1.5 GB

Flashing directions

You require a device like SP Flashtool, Miracle Box, AfterSales SWD, SP MDT AfterSale, etc., to blink this firmware. Get a working USB cable, then comply with the directions listed below-

  • Unpack downloaded firmware to an empty folder
  • Make certain you’ve installed the called for drivers on your COMPUTER.
  • Launch flashtool and also tons the firmware. You might require to wait a few seconds for it to procedure completely
  • Now power off your gadget and also visit this site to check out full blinking guidelines if using SP Flashtool.

If you require any assistance on this gadget or blinking instructions, or you’ve obtained various other contribution- do not hesitate to post in the comments area listed below. We do our best to reply as well as address your questions.Ulefone Armor X7 manufacturing facility stock firmware