Ulefone Note 8P factory signed firmware

Ulefone Note 8P official stock firmware will help you flash and restore your phone to its default factory state. It will remove root, virus, un-brick, and fix your device if it’s stuck on boot screen. If your phone lags, after flashing it should be better.

Additionally, you should consider making a backup of your current firmware, and all other important data on your phone. Flashing will completely erase your phone. Also, you should only flash your device if you actually know what you’re doing. To avoid messing up your device, or turning it into a brick.

It’s also important that your device is charged up to at least 30% so the process is not interrupted due to shutdown.

If there’s a broken link, do not hesitate to report via the comments section or use the contact form.

Build Region Firmware Size
GQ3091EF1_TE637_Ulefone_EEA_20200828_V12 EU (EEA) Download 1.12 GB
GQ3091EF1_TE637_Ulefone_20200828_V09 Non-EU Download 1.12 GB
GQ3091EF1_TE637_Ulefone_EEA_20200710_V10 EU (EEA) Download 1.38 GB
GQ3091EF1_TE637_Ulefone_20200709_V07 Non-EU Download 1.38 GB

Flashing instructions

You need a tool like SP Flashtool, Miracle Box, AfterSales SWD, SP MDT AfterSale, etc., to flash this firmware. Get a working USB cable, then follow the instructions below-

  • Unpack downloaded firmware to an empty folder
  • Make sure you’ve installed the required drivers on your PC.
  • Launch flashtool and load the firmware. You might need to wait a few seconds for it to process completely
  • Now power off your device and click here to read full flashing instructions if using SP Flashtool.

If you need any help on this device or flashing instructions, or you’ve got other contribution- do not hesitate to post in the comments section below. We do our best to reply and answer your questions.