Symphony G10 blink documents (stock firmware) will certainly assist you blink as well as recover your phone to its default factory state. It will remove origin, virus, un-brick, as well as fix your tool if it’s stuck on boot logo design. If your phone lags, after flashing it must be much better.
It is encouraged that you backup existing firmware and all other essential information since, blinking this firmware will entirely remove your phone data. Only blink your device if you really understand what you’re doing. This is to avoid screwing up your gadget, or turning it right into a brick.
Subsequently, make sure the tool is charged up to at the very least 30% so the procedure is not disturbed as a result of reduced battery. If there’s a broken link, do not be reluctant to report through the remarks area or utilize the contact form.
| Build | Firmware | Size |
|---|---|---|
| Symphony_G10 _ HW1_V7 _100620 _ 9.0 | Download | 894 MB |
Flashing guidelines
You require devices like SPD Upgrade Tool or CM2 to blink this firmware. Obtain a working USB cable, after that follow the guidelines listed below-
- Unpack downloaded and install firmware to an empty folder
- Make sure you’ve set up the required drivers on your COMPUTER.
- Launch flashtool as well as load the firmware. You may need to wait a couple of secs for it to process entirely
- Now power off your device as well as go here to read full flashing guidelines if using SPD Upgrade Tool.
If you need any aid on this gadget or flashing directions, or you’ve obtained various other contribution- do not wait to upload in the comments area below. We do our ideal to reply and answer your questions.