Myphone Agua Storm TV (0,v1,v2) stock firmware

Flashing this Myphone Agua Storm TV stock firmware will restore your 0, v1 or v2 smartphone to its default factory state. It will eliminate root, virus, un-brick, and repair your gadget if it’s stuck on boot logo. If your phone lags, after flashing it must be much better.

Additionally, you should consider making a backup of your current firmware, and all other essential data on your phone. Flashing will completely erase your phone. Likewise, you ought to only flash your gadget if you actually know what you’re doing. To prevent messing up your gadget, or turning it into a brick.

It’s likewise crucial that your gadget is charged up to a minimum of 30% so the procedure is not cut off due to shutdown.

If there’s a broken link, do not think twice to report by means of the comments section or use the contact form.

Firmware download link

Name Agua_Storm_TV _20141030 _ v1.14 specialcase.rar
Link Download
Size 227 MB

Flashing instructions

You require a tool like SP Flashtool to flash this firmware. Get a working USB cable, then follow the instructions listed below-

  • Unpack downloaded firmware to an empty folder
  • Make sure you’ve set up the required drivers on your PC.
  • Launch flashtool and load the firmware. You might need to wait a couple of seconds for it to process completely
  • Now power off your device and click here to read complete flashing directions.

If you need any aid on this device or flashing directions, or you’ve got other contribution- do not hesitate to publish in the comments section below. We do our finest to reply and address your concerns.

Add Comment