Itel S15(W6002 E) blink data (stock firmware) will aid you flash and also restore your phone to its default manufacturing facility state. It will get rid of origin, infection, un-brick, and repair your gadget if it’s stuck on boot logo. If your phone delays, after blinking it needs to be better.
It is suggested that you backup current firmware and all various other vital information due to the fact that, blinking this firmware will totally remove your phone data. Likewise, only flash your gadget if you actually know what you’re doing. This is to avoid ruining your device, or transforming it into a block.
Subsequently, make sure the tool is charged up to a minimum of 30% so the process is not disrupted as a result of reduced battery. If there’s a broken web link, do not think twice to report by means of the comments area or utilize the call kind.
|W6002 E-F3108 -9.0- OP-V024-20210413||Download||1.22 GB|
You require tools like SPD Upgrade Tool or CM2 to blink this firmware. Get a functioning USB wire, then comply with the instructions listed below-
- Unpack downloaded and install firmware to an empty folder
- Make certain you’ve installed the called for drivers on your PC.
- Launch flashtool and also tons the firmware. You could require to wait a couple of seconds for it to process totally
- Now power off your gadget and click on this link to check out full blinking directions if utilizing SPD Upgrade Tool.
If you need any kind of assistance on this gadget or flashing guidelines, or you’ve got various other contribution- do not think twice to upload in the remarks area below. We do our ideal to reply as well as address your concerns.