Cubot J3 Pro main stock firmware will assist you flash and restore your phone to its default factory state. It will get rid of root, infection, un-brick, and repair your gadget if it’s stuck on boot logo design. If your phone lags, after flashing it must be much better.
It is recommended that you make a backup of your existing firmware, and all other crucial information on your phone. Flashing will entirely eliminate your phone. You ought to just flash your gadget if you really understand what you’re doing. To prevent ruining your gadget, or turning it into a brick.
To prevent disturbance of the flashing/ firmware setup procedure, guarantee that your gadget is credited a minimum of 30%.
If there’s a damaged link, do not think twice to report through the remarks area or utilize the contact kind.
| Build | Firmware | Size |
|---|---|---|
| CUBOT_J3_PRO _8051 C_V14 _20181025 | Download | 700 MB |
Flashing guidelines
You require a tool like SP Flashtool, Miracle Box, AfterSales SWD Tool, and so on, to flash this firmware. Get a working USB cable television, then follow the directions listed below-
- Unpack downloaded firmware to an empty folder
- Make sure you’ve set up the needed drivers on your PC.
- Launch flashtool and load the firmware. You may require to wait a couple of seconds for it to procedure totally
- Now power off your gadget and click on this link to check out complete flashing directions if utilizing SP Flashtool.
If you require any aid on this gadget or flashing guidelines, or you’ve got other contribution- do not think twice to publish in the remarks area listed below. We do our finest to respond and address your concerns.